Best Area to Buy a Factory in Selangor (2026): Price, Power and Size Compared
Seventeen Selangor industrial areas compared on live asking price, heavy-power availability, average building size and tenure mix. Prices run RM370 to RM819 psf, and the cheapest areas hold the most 1,000A+ stock.
Key Takeaways
- There is no single best area to buy a factory in Selangor. The right one depends on whether your constraint is power, land size, budget or commute, and those pull in opposite directions.
- Asking prices across Selangor run from about RM370 psf in Telok Panglima Garang to RM819 psf in Sungai Buloh, a 2.2x spread.
- Price and power run in opposite directions: Telok Panglima Garang is the cheapest area on the list and has the highest share of heavy-power stock, with 60% of its listings carrying 1,000A or more, while Balakong is near the top on price and has none.
- If you need heavy power, a large plot or both, the outer belt is not the compromise choice, it is the only choice.
- Tenure is close to an area-level fact: Glenmarie, Semenyih and Jenjarom are effectively all freehold, while Puncak Alam has no freehold factory stock on the market at all.
Best Area to Buy a Factory in Selangor (2026): Price, Power and Size Compared
Key takeaways
- There is no single best area. The right one depends on whether your constraint is power, land size, budget or commute, and those pull in opposite directions.
- Asking prices across Selangor run from about RM370 psf in Telok Panglima Garang to RM819 psf in Sungai Buloh, a 2.2x spread.
- Price and power run in opposite directions. Telok Panglima Garang is the cheapest area on this list and has the highest share of heavy-power stock: 60% of its listings carry 1,000A or more. Balakong is near the top on price and has none.
- If you need heavy power, a large plot or both, the outer belt is not the compromise choice, it is the only choice.
- Tenure is close to an area-level fact: Glenmarie, Semenyih and Jenjarom are effectively all freehold, while Puncak Alam has no freehold factory stock on the market at all.
The comparison table
Live asking prices for factories for sale in Selangor, August 2026. Areas with fewer than 10 listings are excluded because their averages are not stable.
| Area | Avg asking (RM psf) | Listings | Avg built-up | 1,000A+ share | Freehold share |
|---|---|---|---|---|---|
| Sungai Buloh | RM819 | 12 | 30,639 sq ft | 17% | 58% |
| Balakong | RM781 | 18 | 16,342 sq ft | 0% | 78% |
| Petaling Jaya | RM744 | 12 | 16,009 sq ft | 8% | 17% |
| Glenmarie | RM716 | 20 | 28,925 sq ft | 5% | 100% |
| Puchong | RM705 | 32 | 22,639 sq ft | 3% | 56% |
| Shah Alam | RM671 | 98 | 41,028 sq ft | 8% | 70% |
| Subang | RM642 | 13 | 29,219 sq ft | 8% | 69% |
| Bandar Puteri Klang | RM614 | 20 | 42,128 sq ft | 10% | 90% |
| Sepang | RM542 | 14 | 30,791 sq ft | 7% | 36% |
| Rawang | RM509 | 21 | 32,794 sq ft | 14% | 76% |
| Port Klang | RM500 | 178 | 63,319 sq ft | 33% | 56% |
| Kapar | RM495 | 51 | 55,334 sq ft | 29% | 90% |
| Puncak Alam | RM475 | 23 | 36,110 sq ft | 9% | 0% |
| Semenyih | RM470 | 25 | 46,974 sq ft | 12% | 100% |
| Jenjarom | RM455 | 16 | 56,035 sq ft | 31% | 100% |
| Banting | RM381 | 22 | 68,476 sq ft | 23% | 50% |
| Telok Panglima Garang | RM370 | 25 | 123,006 sq ft | 60% | 88% |
The pattern most buyers miss: price and power run opposite
Read the table top to bottom and the heavy-power share climbs as the price falls. The cheapest area on the list, Telok Panglima Garang at RM370 psf, has 60% of its stock at 1,000A or above. Balakong, at more than double the price, has none.
This is not a coincidence and it is not a bargain waiting to be taken. It reflects what got built where. The outer belt was planned for heavy industry on large plots with the grid capacity to match, while the central areas were built for lighter industrial and warehousing use closer to the labour pool, on smaller lots, decades ago.
The practical consequence: if your process needs serious amperage, paying more does not get it. A TNB upgrade runs into months and capital, and in older central estates the constraint is often the incoming supply to the estate, not just your building. Buyers who insist on a central address and then discover the power ceiling usually end up back on the outer belt having lost a quarter.
Size follows the same line
Average built-up runs from 16,000 sq ft in Balakong and Petaling Jaya to 123,000 sq ft in Telok Panglima Garang, roughly 7x.
That means area choice is partly made for you by your size requirement. A 60,000 sq ft brief simply has very little to look at in Balakong or PJ, and a 12,000 sq ft brief will find the outer belt is mostly selling something much larger. Before shortlisting areas, fix your built-up range and let it filter the map.
Tenure is close to an area-level fact
Tenure is not evenly mixed. On live stock: Glenmarie, Semenyih and Jenjarom are effectively all freehold. Puncak Alam has no freehold factory listings on the market. Petaling Jaya is only 17% freehold.
If your financing or your exit plan requires freehold, that removes several areas before you look at a single building. Browse by tenure directly: freehold factories for sale, leasehold factories for sale.
Which area, by what you actually do
Heavy manufacturing, high amperage, large plot. Telok Panglima Garang, Jenjarom, Banting, Kapar. Cheapest per sq ft, largest buildings, deepest heavy-power stock. The trade-off is distance from KL and a thinner labour catchment.
Port-driven logistics and distribution. Port Klang and Kapar. Port Klang alone carries 178 live sale listings, the deepest inventory in the state, at RM500 psf with an average building of 63,000 sq ft. Proximity to Northport and Westport is the whole argument.
Light industrial, assembly, workforce-dependent. Shah Alam is the practical default: 98 listings, RM671 psf, 70% freehold, and the mature expressway grid with the deepest labour pool. Subang and Puchong sit alongside at similar rates.
Operations with a client-facing or corporate component. Glenmarie, Petaling Jaya, Sungai Buloh. You pay RM700 to RM820 psf for the address and the commute, and you accept small buildings and thin power. Glenmarie being 100% freehold is a genuine plus for a long hold.
Budget-constrained but wanting to stay reachable. Semenyih, Rawang, Puncak Alam, Sepang. Middle of the table on price, still inside the wider commuting ring. Note Puncak Alam is leasehold only.
Do not shortlist by area alone
The table above ranks averages, and an average hides the building you will actually buy. Two units on the same road can differ 30% or more on rate depending on power, ceiling height, floor loading, loading provision, building age and certification status.
The efficient order is: fix built-up range and power requirement first, filter to the buildings that meet them, and only then compare areas on what is left. That usually produces a shorter and more honest shortlist than starting from a map.
Search live stock by specification: search factories by specs, or browse factories for sale in Selangor and Klang Valley.
Four things to verify before you commit to an area
Area averages get you to a shortlist. These four checks decide whether a specific building works, and all four are cheaper to do before the offer than after.
- Incoming supply, not just the meter. Ask for the TNB bill and the substation capacity serving the estate. In older central estates the constraint is frequently the estate's incoming supply, so a building that shows 600A may not be upgradable to 1,500A at any reasonable cost or timeline.
- Balance of the lease term. For leasehold, a lease under 60 years remaining starts to restrict financing, and banks price the tail. Puncak Alam is leasehold only, and roughly half of Banting stock is, so this check is area-dependent.
- CF and land use category. Confirm the certificate of fitness is clean and that the land use category matches your licensing requirement with the local authority. Conversion after purchase is slow and not guaranteed.
- Container access and turning circle. A 40-foot container needs room to enter, turn and reverse onto the apron. Older small-lot estates in the central belt frequently cannot take one without blocking the road, which is a daily operating cost rather than a one-off.
FAQ
What is the best area to buy a factory in Selangor?
It depends on the binding constraint. For heavy power and large plots, Telok Panglima Garang and Jenjarom (RM370 to RM455 psf, 31% to 60% of stock at 1,000A+). For port logistics, Port Klang (178 listings, RM500 psf). For workforce-dependent light industry, Shah Alam (98 listings, RM671 psf, 70% freehold). For a corporate address, Glenmarie or Petaling Jaya at RM716 to RM744 psf.
Which area in Selangor has the cheapest factories?
Telok Panglima Garang at about RM370 psf on live asking prices, followed by Banting at RM381 and Jenjarom at RM455. These are also the areas with the largest average buildings, so the total ticket is not necessarily small.
Where should I buy if I need 1,000A or more?
Telok Panglima Garang (60% of listings), Port Klang (33%), Jenjarom (31%) and Kapar (29%) carry the deepest heavy-power stock. Central areas such as Balakong, Puchong and Glenmarie have very little, and a TNB upgrade there takes months.
Is Shah Alam a good place to buy a factory?
It is the most balanced option and has the widest choice in the state after Port Klang: 98 live sale listings, RM671 psf average, 70% freehold, average building 41,000 sq ft. You pay a premium over the outer belt for connectivity and labour supply.
Which Selangor areas are freehold?
On live stock, Glenmarie, Semenyih and Jenjarom are effectively all freehold, and Kapar and Bandar Puteri Klang are around 90%. Puncak Alam has no freehold factory listings, and Petaling Jaya is only 17%.
How much does a factory cost in Selangor in 2026?
Live asking prices range from about RM370 psf to RM819 psf depending on area, with the state's deepest markets (Port Klang, Shah Alam) at RM500 to RM671. On a 40,000 sq ft building that is roughly RM20 million to RM27 million before stamp duty and legal fees.
Figures are asking prices from BuyKlang live listings as at August 2026, computed on built-up area, with implausible outliers excluded and areas under 10 listings omitted. Asking prices are the starting point for negotiation, not transacted prices.
Where to live in Selangor?
There is no single best area to buy a factory in Selangor; the right one depends on whether your constraint is power, land size, budget or commute. For heavy power and large plots, Telok Panglima Garang and Jenjarom offer RM370 to RM455 psf with 31% to 60% of stock at 1,000A or above, while Shah Alam is the practical default for workforce-dependent light industry at RM671 psf with 70% freehold. Browse factories for sale in Selangor to compare live stock.
Factories and Warehouses in Port Klang
Archived catalogue records with power, ceiling height and floor loading for every unit:
